Using The Receiver; Switching The Receiver On/Off; Connecting The Headphones/Adjusting The Volume - Sennheiser EM 3731-II - ANNEXE 583 Instruction Manual

Using the receiver

clock
save
M
6.000
H
z
sync
.01 BANK AF
COM
esc
CH
RF % DEV
A B
300 PEAK
True Diversity Receiver EM 3732
100 100
30
50
10
µV 10
2 3
20
Using the receiver

Switching the receiver on/off

The EM 3731-II single receiver is switched on and off with the
button C. The two receivers of the EM 3732-II or EM 3732-II COM twin
receiver are switched on and off together with the
C
button is not a mains switch.
If you only want to use one of the two receivers of the EM 3732-II
or EM 3732-II COM, you can set the second receiver to standby
mode (see "Setting a receiver to standby mode" on page 40).
To switch the receiver on:
button C.
Press the
The display shows the product name (e.g. EM 3731-II) and the serial
number of the current firmware (behind "Software"). The status
display appears after several seconds.
To switch the receiver off:
Press the button
The receiver is switched off but daisy chained signals continue to be
output. This means that:
– the daisy chain outputs
– if the booster supply voltage is switched on (see page 32), it remains
switched on even when the receiver is switched off,
– the signal of the external word clock generator is looped through to
the word clock daisy chain output I.

Connecting the headphones/adjusting the volume

CAUTION! Danger of hearing damage!
Listening at high volume levels for long periods can lead to
permanent hearing defects.
Set the volume for the connected headphones to the
minimum before putting the headphones on.
The EM 3731-II single receiver features a headphone socket 2. The two
receivers of the EM 3732-II or EM 3732-II COM twin receiver have a
common headphone socket 2. This common headphone socket
you to either monitor the audio signal of one receiver or to simultaneously
monitor the audio signals of both receivers.
Set the headphone volume control
it to the left as far as possible.
776.000
01.01 BANK
CH
Connect headphones with a ¼" (6.3 mm) stereo jack plug to the
headphone socket 2.
C
for approx 2 seconds until the display goes off.
Q P
and output the antenna signals.
3
to the lowest volume by turning
button C. The
2
allows