Table of Contents
Advertisement
Freq. occupied
1.
776.000
MHz
776.
000
Tune
B.Ch
U.01
776
960
UHF
MHz
1.
776.000
MHz
.Ch
.16
CEL
Name
B.Ch
+ , - | / 0 1 2 3 4 5 6
7 8 9 * ; < = >
A
A B
C D
E
F G H I J K L M N
OPQRSTUVWXYZ
7
8
save
DEV
777.005
M
H
z
sync
U.01
BANK
AF
COM
esc
CH
You can only select channels that are not occupied. If, during the
B.Ch
last scan, channels were detected that were occupied, these
channels are marked with a warning triangle and
After you have selected the frequency bank and the channel, press the
button 8.
save
The selected frequency bank and the selected channel are set. The
display changes to the selection mode of the operating menu.
Changing the receiving frequency for a channel in the
frequency bank "U"
Each receiver has seven frequency banks. Each of the channels in the
frequency banks "1" to "6" has been factory-preset to a receiving
B.Ch
1.01
frequency (see enclosed frequency tables). The frequency bank "U" (user
bank) has 60 channels to store your selection of receiving frequencies. Via
Bank
the "Tune" menu, you can select the receiving frequencies to be stored in
the frequency bank "U".
Change to the setting mode of the "Bank.Ch" menu and select the
776.
frequency bank "U" and one of the channels "01" to "60" whose
000
frequency you want to change and store (see "Selecting a frequency
MHz
bank and a channel" on page 30).
The receiving frequencies of the channels in the frequency banks
"1" to "6" cannot be changed. When you have selected one of the
frequency banks "1" to "6" and then select the "Tune" menu, the
receiver automatically switches to channel "01" of the frequency
bank "U".
Change to the setting mode of the "Tune" menu and select the
B.Ch
receiving frequency you want to store (see "Setting the receiving
frequency" on page 30).
The selected receiving frequency is set and stored on the selected
channel of the frequency bank "U", i.e. the previously stored frequency
is overwritten. The display changes to the selection mode of the
operating menu.
Entering a name
Via the "Name" menu, you can enter a freely selectable name for the
receiver. The name can be displayed on the status display and can consist
30
of up to six characters such as:
Squel
• letters (without pronounciation marks),
• number from 0 to 9,
• special characters and spaces.
Change to the setting mode of the "Name" menu.
The first character of the name starts flashing.
EL
Turn the jog dial
The selected character starts flashing.
digital audio
Press the jog dial
processing
The first character is accepted and stops flashing. The next character
sync
starts flashing.
Adjustment tips for the operating menu
7
to select a different character.
7
to confirm the selected character.
"Freq.
occupied".
31
Advertisement
Table of Contents
