Adjustment Tips; Synchronizing The Bodypack Transmitter With A Receiver; Cleaning The Bodypack Transmitter - Sennheiser SK 300 G3 Manual

ew G3 SK 300_529670_0109_SP8_PRT.book Seite 22 Donnerstag, 5. Februar 2009 10:26 10

Adjustment tips

Adjustment tips
Synchronizing the bodypack transmitter with a
receiver
When synchronizing the bodypack transmitter with a receiver, please
observe the following:
Only use a bodypack transmitter and a receiver from the same
frequency range (see the type plate on the transmitter and the
receiver).
Make sure that the desired frequencies are listed in the enclosed
frequency information sheet.
Make sure that the desired frequencies are approved and legal in your
country and, if necessary, apply for an operating license.
Synchronizing the bodypack transmitter with the receiver –
individual operation
Upon delivery, the bodypack transmitter and the receiver are synchro-
nized with each other. However, if you cannot establish a transmission link
between bodypack transmitter and receiver, you have to synchronize the
channels of the devices.
For information on automatic synchronization of the bodypack trans-
mitter with the receiver (individual operation), refer to the instruction
manual of the receiver. This information is marked with the
Alternatively, you can set the channel on the bodypack transmitter
manually:
Make sure that you set the bodypack transmitter to the same
frequency bank and the same channel as the receiver (see page 17).
If you still cannot establish a transmission link, refer to the chapter "If a
problem occurs ..." on page 23.
Synchronizing bodypack transmitters with receivers –
multi-channel operation
Combined with ew 300 G3 receivers, ew 300 G3 bodypack transmitters can
form transmission links that can be used in multi-channel systems. In
order to ensure an intermodulation-free transmission, use the same
frequency bank for all transmission links.
For information on automatic synchronization of bodypack transmitters
with receivers (multi-channel operation), refer to the instruction manual
of your receiver. For more information on multi-channel operation, visit
the SK 300 G3 product page at www.sennheiser.com.

Cleaning the bodypack transmitter

CAUTION! Liquids can damage the electronics of the bodypack
transmitter!
Liquids entering the housing of the device can cause a
short-circuit and damage the electronics.
Keep all liquids away from the bodypack transmitter.
Use a slightly damp cloth to clean the bodypack transmitter from time
to time. Do not use any solvents or cleansing agents.
22
icon.