Programming A Macro; Programming Without Timeout - THOMSON ROC 850 - AVEC CODES Manual

Programming a Macro

You can memorize up to 9 control sequences (Macros) in your remote control. Each sequence
can run a series of 20 instructions. Once memorized, press the
screen key for the sequence to run. Before programming, take a few minutes to write down the
sequence to compose.This will be particularly useful to achieve your programming and use it
later.

Programming without timeout

1.
2.
3.
4.
5.
6.
7.
8.
Activate the touch screen by pressing it.
Press and hold the
seconds) and the Setting screen displays. Release the
Press the
MACRO
displays.
Press 1 to 9 to number the sequence.
A new screen displays, using the keypad (
desired ( , ,
TV VCR
mode selected, as well as the
Compose your sequence:
a) Press the sequence of keys to memorize in the exact order required.
b) Use the
SCREEN
c) Use a key for the keypad mode (
devices (start a TV ser, select a channel, switch on a satellite
receiver, ...).
Press the
MACRO
automatic when reaching the 20 keys possible.
Press the key on the touch screen to return to the previous menu.
EXIT
Note:
• In certain cases, you may have to include a timeout between 2 keys. Refer to next
paragraph.
• Secondary keys accessible via the
• You cannot include a Macro inside a Macro.
MACRO
6
( ) key until the red indicator remains lit (2-3
SETUP
5
( ) key on the touch screen.The MACRO screen
, ...).The touch screen displays the keys of the
SAT
and
SETUP
key on the touch screen to go to the 2nd screen.
,
TV
5
( ) key on the keypad to save the sequence. Saving is
key cannot be included in a Macro.
S
12
5
( ) key and the touch
SETUP
2
), press the key of the mode
keys.
MACRO
, ...) to control different
VCR
key.