Smeg SC106-2 Instructions Manual page 13

Instructions for the user
7.7.3 Automatic cooking
Automatic cooking is the function which allows a cooking operation to be
started at a set time and then ended after a specific length of time set by
the user.
Select a cooking function, adjust the desired cooking temperature or leave
the preset temperature (see point "7.6 Selecting a function") and press
PT1 twice. The display will show the figures and the symbol
(flashing).
Turn PT1 to the right or left to set the minutes of cooking (from 00:01 to
23:59).
After setting the duration, press PT1 once.
The symbol and the current time will appear on the display.
Turning PT1 to the right increases the time, allowing the desired end
cooking time to be set.
A few seconds later, the and symbols will stop flashing and remain
constantly on, and the oven will start to wait for the starting time set. At the
end of this time the message STOP will appear on DSP, cooking will be
interrupted and a buzzer will sound which can be deactivated by pressing
PT1 once.To exit from the automatic cooking settings, press PT1 again.
To switch the oven off completely, turn PT2 to the "0" symbol.
Modifying the data set
The cooking duration can be changed before cooking starts or while it is in
progress. Press PT1 once, the symbol starts flashing. Turn PT1 and
select the desired value. A few seconds after the last change, the
symbol will stop flashing, and cooking will restart with the new settings.
The cooking end time can be changed before cooking starts. Press PT1
twice; the symbol starts flashing. Turn PT1 and select the desired
value. A few seconds after the last change, the symbol will stop
flashing, and automatic cooking will restart according to the new settings.
Instead, to change the preset temperature during cooking turn PT1 to the
right or left in order to increase or decrease the value.
52