Table of Contents
Advertisement
Instructions for the Installer
4.2 Fitting the adhesive foam rubber strip
Fit the adhesive foam rubber strip
(supplied with the hob) around the
outside edge of its surround.
It will act as a cushion between
the surface of the surround and
that of the cabinet. The diagram
on the right shows the correct
position for the foam rubber strip.
Take great care when fitting it to
ensure that it does not project
beyond the outside edge of the
frame.
4.3 Fitting the fixing clips
Fit the fixing clips in all the points
marked with an arrow. The clips
fix the hob an ensure that it is
centred correctly.
To fit the clips to the hob, simply
press them gently horizontally into
the groove provided (fig. A).
Then turn them upwards to fix
them permanently in place (fig. B).
4.4 Fitting the hob into the hole in the work-top
Take special care when fitting the hob into the work-top. If the procedures are not
carried out correctly, exactly as described, the hob may be damaged.
Before fitting the hob, remove
the pan stands (if fitted) and the
burners from the hob.
When fitting the hob, first rest the
surround entirely on the back
edge of the hole in the work-top.
Do not apply leverage to the
surround; since this part is very
delicate
there
is
a
risk
of
damaging it.
Then lower the front of the hob
until the appliance is completely in
place.
8
Advertisement
Table of Contents
