Choice Of Location; Fitting - Smeg SI3633B Manual To Installation And Use

EN
2 2 / / USING YOUR APPLIANCE
• • CHOICE OF LOCATION
The distance between the edge of your appli-
ance and the side and rear walls (or partitions)
must be at least four centimetres (area A).
Your appliance can be easily integrated above
a cabinet, an oven or a build-in household
appliance. You must simply ensure that the air
intakes and air outlets are clear (See
"Description of Your Appliance" section).
• •
BUILD-IN
Follow the diagram above.
Glue the foam seal underneath your appliance by
following the outline of the worktop upon which
your appliance will rest. This will allow you to
achieve an airtight seal with the worktop.
Attach the clips to the hob*.
*Depending on model
Tip
If your oven is located below your hob, the hob's thermal safety measures forbid the
simultaneous use of the hob and the pyrolysis program of your oven.
Your hob is equipped with an anti-overheating safety device.
This safety can be activated, for example, when the hob is installed over an oven that is not
sufficiently insulated. If this occurs, a series of small lines appear in the control panel. In this
case, we recommend that you increase the ventilation of your hob by creating an opening in
the side of your cabinet (8 cm x 5 cm) and/or you can also install the oven insulation kit that
is available from the After-Sales Service Department.
Warning
You must ensure that the air intakes located under your cooking appliance remain
clear at all times. For all types of installation, your induction hob needs proper ventilation.
5 5 8 8
6 6 , , 4 4
Entrée d'air
4 4 9 9
A
A A b b o o v v e e a a n n o o v v e e n n
18
5 5 1 1
Sortie d'air
5 5 6 6
A A b b o o v v e e a a c c u u p p b b o o a a r r d d o o r r
d d r r a a w w e e r r u u n n i i t t
MINI 4 mm