Table of Contents
Advertisement
8. MAINTENANCE INSTRUCTIONS
1.
the unit.
2. Use a dry cloth to wipe all battery corrosion and other dirt or oil from
3.
9. STORAGE INSTRUCTIONS
1. Charge battery to full capacity before storage.
2. Store this unit at temperatures between - 4°F- 140°F ( - 20°C- 60°C).
3. Never completely discharge the battery.
4. Charge after each use.
5.
over-discharge.
10. TROUBLESHOOTING
Jump Starter
PROBLEM
not turn on.
The thermometer symbol
The jump starter will not
recharge.
When cable is correctly
connected to both battery
and jump starter: Green LED
blinking; Red LED off; no beep.
Smart Cable LED and Alarm Behavior
BEHAVIOR
Green Ready LED blinking;
Red Fault and Clamp Reverse
LEDs off; no beep.
SOLUTION
Make sure the unit is charged.
The unit is too hot or cold. The thermometer
symbol will disappear when the condition
is removed.
Make sure the power source is live.
Check connections.
Verify the charge level of the jump starter is
at least 40%.
Do not attempt to jump start your vehicle
more than three consecutive times. If
but reverse charging protection did not
activate. User can turn key to jump start
the vehicle.
REASON
Cable is connected to jump starter only.
• 7 •
Advertisement
Table of Contents
