2. Plug your charger into a live AC or DC power outlet.
3.
that charging has begun.
4. The jump starter will fully charge in 4-5 hours. When the unit is fully
5.
and then remove the charging cable from the charger and the unit.
7. OPERATING INSTRUCTIONS
7.1 JUMP STARTING A VEHICLE ENGINE
NOTE: Use only model number SA934 jump cable.
IMPORTANT: Do not use the jump starter while charging its internal battery.
IMPORTANT: Using the jump starter without a battery installed in the
NOTE: The internal battery must have a charge if at least 40% to
jump start a vehicle.
1. Turn the ignition OFF.
2.
3.
4.
of the battery. Connect the NEGATIVE (BLACK) clamp to the vehicle
chassis or engine block away from the battery. Do not connect the
to a heavy gauge metal part of the frame or engine block.
5.
post of the battery. Connect the POSITIVE (RED) clamp to the vehicle
chassis or engine block away from the battery. Do not connect the
a heavy gauge metal part of the frame or engine block.
6. The green LED on the smart cable should light.
NOTE:
draw from the jump starter may activate short circuit protection in the
automatically reset.
7.
before attempting to start the vehicle again.
NOTE:
Troubleshooting
smart cable will automatically reset.
• 5 •