Table of Contents
Advertisement
Use this item to set Link ASPM, Link Width,VC1 Traffic Support.
3-7 Integrated Peripherals
CMIX-SB700 Revision
Superio Function Setup
onchip IDE Device
Onchip SATA Device
Onchip PCI Device
↑↓→← Move Enter: Select +/-/PU/PD: Value F10:Save ESC: Exit F1:General Help
F5:Previous Values
Super IO Device
Please refer to section 3-7-1
OnChip IDE Device
Please refer to section 3-7-2
OnChip SATA Device
Please refer to section 3-7-3
OnChip PCI Device
Please refer to section 3-7-4
3-7-1
Super IO Device
Power On By Keyboard
Power On By Mouse
Onboard FDC Controller
Onboard Serial Port 1
UART Mode Select
* IRDA Duplex Mode
Onboard parallel port
Parallel port Mode
ECP Mode USE DMA
PWROM After PWR-Fail
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDD) installed on the system
board and you wish to use it. If you install add-on FDC or the system has no floppy drive,
select Disabled in this field. The settings are: Enabled and Disabled.
Onboard Serial Port1
Select an address and corresponding interrupt for the first and the second serial ports. The
settings are: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.
UART Mode Select
This item allows you to determine which InfraRed(IR) function of the onboard I/O chip, this
functions uses.
IrDA Duplex Mode
This field is available when UART Mode is set to either ASKIR or IrDA. This item enables
you to determine the infrared function of the onboard infrared chip. The options are Full and
Phoenix – AwardBIOS CMOS Setup Utility
Integrated Peripherals
F6:Optimized Defaults
Phoenix – AwardBIOS CMOS Setup Utility
Super IO Function Setup
Disabled
Disabled
Enabled
3F8/IRQ4
IrDA
Half
378/IRQ7
SPP
3
Always Off
F6:Optimized Defaults
2.5.0
Press Enter
Press Enter
Menu Level >
Press Enter
Press Enter
F7:Standard Defaults
F7:Standard Defaults
28
Item Help
Item Help
Menu Level >>
Advertisement
Table of Contents
