Table of Contents
Advertisement
3-6-2 HT Link Control
HT Link Width
HT LinkFrquency
IH Flow-Control Mold
HT Link Trislate
2X Lclk Mold
Disabled
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values
HT Link Width
The optional settings are :Auto，8 Bit，and 16 Bit.
HT Link Frequency
The optional settings are: Auto，200MHz, 4000MHz, 600 MHz and 800Mhz.
IH Flow-Control Mode:
Isochronous (ISOC) Flow Control Mode enable will make the HT Link communication have
the complex ordering rules for Isochronous source to make sure it can get service from the
system with deterministic worst-case latency. However, the latency time cost of ISOC flow
control mode is an important consideration. Normal flow control mode will be a simpler
solution for most system.
HT Link Tristate:
Disabled mode will make the link transmitter is driven but in and under fined state during the
disconnect sequence. And the PHY (transmitter) is placed in LS0. LS0 state keeps all lanes
active to maintain DLL and phase recovery lock.
Enabled mode will make the link transmitter is placed into high impedance states during the
disconnect sequence. And the PHY (transmitter) is placed in LS1, LS2 or LS3. LS1, LS2 and
LS3 are each states that shut down parts of the PHY to save power.
LS1 state: CLK running, CAD/CTL sending TxIdle.
LS2 state: CLK/CAD/CTL sending TxIdle.
LS3 state: CLK/CAD/CTL sending either HiZ or TxGndTrm.
3-6-3 PCIE Configuration
P2p h/w Primary/Secondary
GFX Port 1
GFX Port 2
GPP-PE2
GPP-PE3
GPP-PCIELAN
NB-SB Port Features
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values
GFX Port 1
Use this item to set PCI E Gen2 High Speed Mold, Link ASPM and Link Width .
GPP-PE3/ GPP-PCIELAN/GPP-PE2
Use this item to set PCI E Gen2 High Speed Mold and Link ASPM.
NB-SB Port Features
Phoenix – AwardBIOS CMOS Setup Utility
HT Link Control
Auto
Auto
Disable
Disabled
Disabled
F6:Optimized Defaults
Phoenix – AwardBIOS CMOS Setup Utility
PCIE Configuration
F6:Optimized Defaults
Menu Level >
F7:Standard Defaults
Disabled
Press Enter
Press Enter
Press Enter
Menu Level >
Press Enter
Press Enter
Press Enter
F7:Standard Defaults
27
Item Help
Item Help
Advertisement
Table of Contents
