Troubleshooting Guide - Smeg FL224APZD Instructions For Use Manual

Table of Contents

Advertisement

Troubleshooting guide

Fault:
The appliance does not
operate after connection to the
mains:
Cooling system operates
continuously without
intermittent stoppages:
Excessive ice formation at the
rear interior wall of the freezer:
Water dripping from the
appliance:
Bulb replacement:
Helpful hints
Cause/Remedy
• Check if there is power in the socket and if the appliance is
switched on.
• Ambient temperature too high.
• Frequent opening of the door, door open too long.
• Door not closed properly (particle between door gasket, sagged
door, check gasket sealing, etc...).
• Excessive quantity of fresh food inserted at once.
• Refrigerator probe (A) is clogged with fresh food. Relocate the
food to provide air circulation around the probe (certain models
only).
• Check air circulation for suffi cient cooling of the compressor, and
clean the condenser.
• Frequent opening of the door, door open too long.
• Inserting hot food in the freezer.
• Food or dish is touching the rear interior panel of the refrigerator.
• Bad door sealing; clean or replace the gasket if dirty or damaged.
• Drain outlet is clogged, drain water drips past the collection
groove.
• Clean the clogged outlet using plastic straw.
• Thaw thick ice deposits manually (see chapter Defrosting).
• Before replacing the light bulb, disconnect the appliance form the
power supply (pull the power cord from the wall socket).
B – Insert the screwdriver into the cover slot, lift it and remove the
cover.
Replace the bulb with the equivalent new bulb (E 14, same
voltage as the original one) and replace the cover back to its
position.
• Don't forget: the old bulb does not belong to organic waste.
• Light bulb is consumption material and is not covered by the
warranty!
• If none of the above proves effective and you can not remove
the fault yourself, disconnect the appliance from the mains ( see
chapter regarding the ON/OFF function), pull the power cord from
the wall socket, wait for approximately 10 minutes and reconnect
the appliance.
If the fault persists call the nearest service center and tell them
the information from the rating plate: type of appliance, model and
serial number, located inside the appliance.
15

Advertisement

Table of Contents
loading

Table of Contents