Advertisement
READ AND SAVE THESE INSTRUCTIONS – Your Safety An the Safety of Others Are Very Important.
We have provided many important safety messages throughout this manual and on your appliance.
Read all instructions before using your appliance and always obey all safety messages.
RECOGNIZE SAFETY INFORMATION
This is a safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others.
UNDERSTAND SIGNAL WORDS
A signal word – DANGER, WARNING, or CAUTION – is used with the safety-alert symbol. DANGER identifies the most serious hazards. It means you can be killed or seriously injured if you do not immediately follow instructions. WARNING means you can be killed or seriously injured if you do not follow instructions. CAUTION indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury.
FOR YOUR SAFETY
CHILD SAFETY
Before you throw away your old minibar:
ELECTRICAL INFORMATION
To reduce the risk of fire, electric shock, or injury to persons when using this minibar, follow basic precautions, including the following:
Excessive Weight Hazard.
Use two or more people to move and install this minibar.
Failure to do so can result in back or other injury.
Always place the minibar in a dry place with satisfactory ventilation. Never expose it to direct sunlight or install it outdoors.
The compressor type cooling system produces heat and requires good ventilation so rooms with poor ventilation are not very suitable.
Keep ventilation openings, in the minibar enclosure or in the built-in structure, clear of obstruction.
The minibar should be installed in a room in which there is a ventilation opening and it is essential not to obstruct the grilles that allow the minibar to be well ventilated. Avoid positioning the minibar where it is exposed to directly sunlight or close to other sources of heat. If this is unavoidable, in order to prevent the proper operation of the product from being compromised, a suitable insulation board must be used. Otherwise, locate the minibar at least 1¼" (3 cm) away from electrical or gas cookers and at least 12⅛" (31 cm) away from combustion heaters or radiators.
Minimum installation distances:
from the top: 2'' (50 mm). If it is not possible to guarantee this distance, a ventilation opening with the dimensions and position shown in the figure below is required.
from the back: 2" (50mm)
from the sides: 2" (50mm)
from the floor: maximum feet length
To allow proper cooling of the condenser, the minibar must not be placed too close to the wall. To prevent this, there are two plastic spacers at the lower back of the minibar.
Position the minibar so that the door can be opened fully. Take care not to scratch or damage the floor when installing the minibar on parquet or linoleum. If necessary, when positioning slide the minibar over pieces of wood or a mat to the point decided for connection to the electrical mains.
Place the minibar on a firm, level surface. To compensate for any unevenness in the floor, the minibar has four adjustable feet. This gives it added stability and makes it easier to move around and position. Take great care when moving the minibar not to damage the floor (for example, when installing on a parquet floor).
Connect the minibar's power supply lead to a electrical outlet, installed in accordance with electrical safety regulations. The rated voltage and frequency are stated on the nameplate inside the minibar. The minibar can tolerate fluctuations in voltage of between -15% and +10% of the nominal value indicated on the data plate. If the power supply cord lead has to be replaced, this operation must only be carried out by an authorized Smeg technical service engineer. The power plug must be accessible after the minibar has been installed.
When the minibar door is opened, the light comes on; it remains on until the door is completely closed again.
The minibar comes complete with several shelves which can be set at different heights by placing them on the runners provided. Then change the position of the shelf or shelves as you require. For easy removal of all internal accessories, the door has to be opened completely.
The inside of the door is fitted with a shelf for storing tubes, small packages and jars. The bottom of the door has a shelf to take vertical bottles and cans.
The top door shelf and the bottle shelf, as well as the bottle/jar container, are not interchangeable and must not be inverted after being taken out for cleaning. Otherwise, bottles may fall out when the door is opened.
The shelf and container can be removed for cleaning. To remove them from the door, tap them upward with your fist first on one side of the insertion zone and then on the other. Do not place excessively heavy bottles on the bottle shelf, and place bottles on the shelf gently when loading them.
The ventilation must never be obstructed in any way; this would impair operation of the minibar.
THE MINIBAR CAN OPERATE IN TWO DIFFERENT MODES:
NORMAL: a switch is used to select the minimum and maximum temperature.
SMART (function available only for hotels): detects the presence of a guest in the room and starts the compressor when the guest leaves.
The minibar is set to NORMAL by default.
It is possible to adjust the storage temperature inside the minibar by using the selector positioned on the front of the minibar.
changes in weather conditions (temperature and humidity) and the frequency with which the door is opened may affect the minibar's operating temperatures.
The SMART SYSTEM switches the compressor on and off according to whether the guest is in the room. An Energy Saver is required in order to use the SMART system.
The customer enters the room and inserts the card into the card slot, the Energy Saver sends a signal to the Smart System to indicate that there is a guest in the room and the minibar's compressor stops (the products inside remain fresh for a long time because of the cold released by the accumulation plate). When the customer leaves the room and removes the card from the Energy Saver, another message is sent to the Smart System and the minibar starts up again. If the guest remains in the room for a long time and the cold that has accumulated in the plate runs out, the minibar starts up again automatically in order to keep the products inside it cool. The minibar operates in high energy saving mode if the room remains unoccupied for a long time.
To make the connection "SIGNAL" is necessary:
There are two power plugs (POWER and SIGNAL) on the back of the minibar.
Connect the "POWER" plug to the room socket to be used for the Minibar (socket not connected to the energy saving unit).
Connect the "SIGNAL" plug to any socket that is connected to the Energy Saver.
NOTE: The Minibar operates in NORMAL mode if the "SIGNAL" plug is not connected. This means that its operation is not based on the presence of a guest in the room and is regulated by the temperature chosen by the Customer through the selector described above.
If the POWER and SIGNAL cables are inverted, the Minibar will operate when the guest is in the room and it will switch off when the guest is out of the room.
To make sure that the cables have been connected the right way round, make sure that the light inside the minibar lights up when the minibar door is opened, after making sure that:
If the light does not come on, invert the two power cables.
If you switch the power off, do not turn it back on (reconnect the minibar to the power supply) for at least 15 minutes. Otherwise, the compressor may stop for a few minutes before resuming normal operation.
The minibar must never be cleaned by children.
Before cleaning, disconnect the electrical plug from the outlet. Clean the outside using only water and a gentle liquid detergent or an ordinary detergent for washable surfaces (such as a window-cleaning product). Never use products containing abrasives or substances which may attack the lacquered or painted parts, acids or chemical solvents. Use a sponge or a soft cloth. Do not use steam cleaners to clean the inside; we recommend the use of refrigerator-specific disinfectants.
Remove the shelves and accessories, taking care not to apply excessive force when removing. Follow the instructions provided in the "Top door shelf and bottle container" section carefully. Never wash removable plastic parts in the dishwasher; use only warm water and washing-up liquid or water and vinegar. Take care not to wet the electrical lighting components with water or detergents. Clean the seals with warm water and then dry.
Make a periodic check on the condensation drip tray at the rear, and clean it if necessary.
To access the condensation drip tray it is necessary to remove the rear panel.
If the minibar is to be out of use for some time, turn the temperature selector to OFF.
Then empty the minibar, disconnect it from the outlet, and dry any residual moisture which has collected. Leave the door ajar to prevent the humidity and trapped air from creating unpleasant smells.
Your new minibar is designed and built to strict quality standards. This section is intended to enable you to identify the origin of any malfunctions which may occur before contacting the Smeg After-Sales Service.
PROBLEM | POSSIBLE CAUSE | PROBABLE SOLUTION |
Device not cooled sufficiently |
|
|
|
| |
|
| |
Too much condensation forming in the device |
|
|
|
| |
|
| |
Temperature inside the unit too cold |
|
|
If the minibar does not work or it malfunctions, make sure that: |
|
|
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download Smeg FAB5 - Refrigerator One Door 50's Style Manual
Advertisement
Thank you! Your question has been received!
Need Assistance?
Do you have a question about the FAB5 that isn't answered in the manual? Leave your question here.