Table of Contents
Advertisement
Setting fan mode to high increases the cooling fan speed. Set this option to use the pro-
jector at high altitude (over xxxx meter / yyyy feet above sea level)
Press
. Select from Standard/High with
Projection mode
Sets projection mode in accordance with placement style.
The following four modes are available.
- Standard
- Ceiling (TDP-ET10 only)
- Rear
- Rear ceiling (TDP-ET10 only)
Press
. Select with
Keypad Light
Set keypad light on or off.
Press
. Select from On/Off with
Reset
Reset Setup MENU adjustments and settings to factory default.
Press
. Confirmation window will appear and select [Yes] with
and press
to reset.
Reset All
Resets all adjustments and settings except language to factory default.
Press
. Confirmation window will appear and select [Yes] with
and press
to reset.
■ Status display MENU
Video format
Display video sigal format of current input signal.
H Frequency
Display Horizontal sync frequency of current input signal.
V Frequency
Display Vertical sync frequency of current input signal.
Audio format
Display audio signal format of current input signal.
Lamp Time
Display time of lamp use.
Displays lamp time as a measure of when the lamp should be replaced. (Cannot be used
as a counter of guaranteed lamp time) When displayed time approached approximate
2,000 - 3,000 hours, consult with a store about getting a TLPLET10 replacement lamp (sold
separately) prepared.
/ [UP] [DOWN] key.
/ [UP] [DOWN] key.
/ [UP] [DOWN] key.
47
p.22
/ [ - ] or
/ [ + ] key
/ [ - ] or
/ [ + ] key
Advertisement
Table of Contents
