Chapter 1: Connecting Your System - Night Owl BWNIP2 Series User Manual

Chapter 1: Connecting Your System

1
Place the Wi-Fi NVR in a central location. The
Wi-Fi NVR must be within the range of all the
cameras' final mounting positions.
4
HDMI
Plug the other end of the HDMI cable into the
back of your TV or Monitor.
NOTE: To view cameras, TV / Monitor must be tuned
to the same input the HDMI is plugged into.
7
USB
Plug the USB mouse into the USB port on the back
of the Wi-Fi NVR.
10
Charge the batteries for at least 3 hours. Press the
button on the camera's belly to release the
battery cartridge and insert the batteries.
NOTE: Each camera requires 2 rechargeable
batteries, but can hold up to 4 batteries.
2
Connect the two included antennas to your Wi-Fi NVR.
This will ensure you achieve the maximum wireless
range for transmission from your wireless cameras.
5
ETHERNET
Plug one end of the included Ethernet cable into
the LAN port on the back of the Wi-Fi NVR.
8
POWER
Connect the Wi-Fi NVR power adapter to the
Power Input on the rear of the Wi-Fi NVR.
11
Lift the rubber piece on the camera's belly and
connect the USB cable to the camera and a USB
power supply. The batteries MUST be installed
or the camera(s) will not charge.
10
3
HDMI
Plug one end of the included HDMI cable into the
HDMI port on the back of the Wi-Fi NVR.
6 6
RESET
LAN1 LAN2
ETHERNET
Plug the other end of the Ethernet cable into a port
on the back of your router or modem.
(Router Not Included)
9
Plug the Wi-Fi NVR power adapter into a surge
protector or Uninterruptible Power Supply (UPS).
(Surge protector and UPS not included)
STOP: BEFORE installing, the cameras must be
paired to the Wi-Fi NVR. Do not mount the cameras
until you have completed Step 3: Startup Wizard.
LAN3 LAN4 WAN