Table of Contents
Advertisement
12
C. TABLE
Installation of the table is quite simple. The only concern is to keep grit from getting into the
mounting yoke. Grit can make the table rock or difficult to move.
1. Mount the table yoke (Pt.#51) to the saw frame and secure with the two 5/16"x18xW' L Hex
bolts and washers as shown in Figures. Make sure there is not any foreign material between
the yoke and frame. Align the pins and tighten the bolts down. There is no need to "reef" the
bolts down.
Figure 8 Shows positioning trunnion support bracket (yoke) on saw frame.
2. Remove the table insert and the tapered pin from the table. Slip blade through the table slot
and set the table trunnions (Parts #50) onto the yoke. Finally, secure the table to the yoke by
tightening the two star knobs. (1) Remember to position table so that the miter is to the right of
the blade (See Figure 9).
3. Always keep the tapered table pin (Pt#46) in place when operating bandsaw.
Figure 9 Shows location of star knobs.
Advertisement
Table of Contents
