Table of Contents
Advertisement
Figure 80
1. Bolt
2. Spacer
3. Locknut
4. Spring
2. Place the spacer and spring onto the grass deflector.
Place one J end of the spring behind the deck edge.
Note: Make sure one J end of the spring is installed
behind the deck edge before installing the bolt as
shown in Figure 80.
3. Install the bolt and nut. Place one J hook end of the
spring around the grass deflector (Figure 80).
Important: The grass deflector must be able
to rotate. Lift the deflector up to the full open
position and ensure that it rotates into the full
down position.
5. Spring installed
6. Grass Deflector
7. J hook end of spring
Cleaning
Cleaning Under the Mower
Service Interval: Before each use or daily
Remove the grass buildup under the mower daily.
1. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Raise the front of the machine and use jack stands to
support the mower.
Waste Disposal
Engine oil, batteries, hydraulic oil, and engine coolant
are pollutants to the environment. Dispose of these
according to your state and local regulations.
53
Advertisement
Table of Contents
