Table of Contents
Advertisement
MX-J30/MX-J330/MX-J35R
CD Changer mechanism
1.Remove the top cover and CD changer mechanism.
2.The extension wire "A" is connected with CN651 and CN404.
System control P.C.board
1.Remove the top cover and CD changer mechanism.
2.Remove the front panel assembly.
3.The card wires "B","C","D" which passes the back of the
substrate A is extracted, and it is inserted in each connector.
connect to "B":CN416
"C":CN402
"D":CN403
4.Remove a flat wire "E" from the hook1, and connect it with
connector CN212.
5.Disconnect the card wire from connector CN807 on the
system control P.C.board.
6.Remove a 2pin wire "F" from the hook2 on the substrate B.
7.Six screws "G" are removed, and the bracket is removed.
8.Two screws "H" on the system control P.C.board are removed.
and the system control P.C.board is knocked down forward.
9.The extension wire "I" is connected with CN807 and CN306.
Extension wire parts No.
A : VWF1019-45TTA
| : VWF1211-28TTB
2-32
CN404—¥]
CN651
substrate B HOOK
2
2pin wire "F" \@
substrate A
Se
Bracket
substrate A
CN807
y 2pin
} wire "F"
'substrate B
Right side
Advertisement
Table of Contents
