JVC MX-J30 Service Manual page 31

m@ Removing the Rolling panel Panel assembly
(See Fig.10 and 11)
1. Disconnect the card wires from connector CN810,CN809,
CN807,CN803,CN802 on the upper system control & FL
board and on the rolling panel assembly on the reverse
side of the front panel assembly
2. Remove the six F screws attaching the stay bracket.
Remove the four G screws attaching the rolling panel
3. assembly.
* Disconnect the flat wire extending from the phones
board through the slit of the rolling pane! assembly.
@ Removing the Cassette Mechanism Assembly
(See Fig.12)
* Prior to performing the following procedure, remove the
rolling panel assembly.
1. Remove the four H screws and four H1 screws attaching
the cassette mechanism assembly.
MX-J30/MX-J330/MX-J35R
CN803
CN802
System control & FL board
Fig.10
Stay bracket
Cassette mechanism
H1 H1 assembly
Fig.12
2-11