JVC MX-J30 Service Manual page 32

MX-J30/MX-J330/MX-J35R
@ Removing the System Control & FL Board System control
(See Fig.13 and 14) & FL board CN803
CN809 CN802
1. Disconnect the card wires and flat wires from connector
CN807,CN808,CN806,CN812,CN810,CN803,CN802,CN
809 on the system control & FL board respectively.
2. Disconnect the 2pin wire from connector CN811 on the
system control & FL board.
3. Remove the six F screws attaching the stay bracket.
4. Remove the two | screws attaching the system control & CN807 e
FL board.
CN808
—_CN806
Fig.13
Stay bracket F
ee eae M@ Removing Each Board of the Front Panel
Fig.14
Assembly (See Fig.15 and 16)
M Power switch
qt L
together with bracket.
* Remove the flat wire extending from the phones
board through the slit of the rolling panel assembly. pq Phones board
4. Remove the four M screws attaching the CD eject board
and unsolder the flat wire.
* Remove the rolling panel assembly. sl
Fig.15
5. Pull out the volume knob and nut toward the front.
6. Remove the two N screws attaching the volume board
Unsolder Volume board
and unsolder the flat wire.
7. Remove the three O screws attaching the function board
1 and unsolder the flat wire.
N
8. Remove the four P screws attaching the function board 2.
Se
P
i —
. Function
O board 2
Function board 1 | |
P
O ps
Fig.16