MX-J30/MX-J330/MX-J35R
Mi Removing the head Amp.and Mechanism
Control P.C.Board (See Fig 4)
2.After turning over the cassette mechanism
assembly,remove the five screws "A" retaining
the head amp. and mechanism control PC.
board
3.Disconnect the connectors CN303 and CN304
on the P.C.Board and the connectors CN1 on
both the right and left side ree! pulse
P.C.Boards.
4.When necessary, remove the 4pin parallel
wire soldered to the main motor
board
board
i Removing the Capstan Motor Assembly
2.While raising the capstan motor, remove the
capstan belts A and B respectively from the
motor pulley (See Fig 6).
Caution 1: Be sure to handle the capstan
belts so carefully that these belts
will not be stained by grease and
other foreign matter. Moreover,
these belts should be hand while
referring to the capstan belt
B
B
B
B
hanging method.
Capstan motor
Capstan
;
Capstan
belt A
|
; |
belt B
Motor pulley
Capstan
Capstan
belt A
belt B
2-24