Mitsubishi FREQROL FR-A024-0.1K Instruction Manual page 16

2.
NOMENCLATURE AND F W C T W S
rn
Parameter Unit Location
The parameter unit can be mounted directly on the inverter, or installed in a remote location
with an optional cable.
In a remote installation, the parameter unit may
be used
as a hand-held unit or mounted in an
enclosure.
Removal and installation of the parameter unit is permissible while the inverter
i s
powered up
or in operation.
rn
Removing and installlng the Parameter Unit
Removing the parameter
Unn
from the Inverter
The parameter unit is fixed to the inverter with clamp
screws. Follow the steps indicated below to remove it
from the inverter.
(1) Open the cover at
the front of the parameter unit.
WMle
pressing
to
the right against the hinge (1)
with
the thumb lightly pressing on the lug
at the upper left of the cover, pull the mver
(2), at the upper right of the cover.
I
I
I
(2) Remove the clamp screw from the parameter unit
Then, remove the parameter unit from the inverter.
Installing the parameter unH on the inverter directly
(1)
Connection
Insert the parameter unit connector into the connec-
tor in the inverter as shown in the illustration in the
lee.
(Press
on
the parameter unit to insert the connector
securely.)
Clamp
the parameter unit to the inverter with the
clamp screw.
(2) Clamping the parameter unit
I
1
N o ( . :
Whar inftailing the
p a r a m e t e r
unit
to the
ilverter
directly. it
must be mounted on
the
front cover
of
Me hvener. Never
ircstall it
on the inwrter
with
the
lront cover removed.
- 4 -