Power supply wiring
Be sure to connect the power supply wiring to the
•
power supply terminal block, pass each phase wire
through separate rubber sleeves and fix with the
included clamps.
Fix the ground wiring with the included clamp by
•
taking care not to apply external pressure on the
terminal area.
Pass the power supply wiring and ground wiring
•
through their respective rubber sleeve and fix with
the included clamps to prevent water from entering
the electrical components box.
6
5
7
8
9
1 Power supply (See 12.3 Requirements)
2 Fuse
3 Earth wire
4 Electrical components box
5 Insulation sleeves
6 Power supply terminal block
7 Ground terminal
8 Clamp (accessories)
9 Rubber sleeve
01_EN_3P748230-1.indd 37
How to pass wire through the rubber sleeve:
1
Remove the rubber sleeve (detachable portion).
2
Place the wire.
4
1
3
2
3
Attach the rubber sleeve (detachable portion).
Attach by inserting the electrical components box
edge into the slit of the rubber sleeve.
4
Fix with a clamp.
Fix by passing the clamp through the hook on the back.
Electrical
components
box edge
37
23/01/2023 17:24:39