Figure 29. Installation of the PSU cage
After this task is completed
1. Install the chassis to the rack (see
2. Reinstall the nodes into the chassis (see
3. Reinstall each PSU slot with a PSU or PSU filler (see
Installation of a PSU
4. Proceed to complete the parts replacement (see
Node component replacement
Follow instructions in this section to remove or install the node components.
Node replacement
Follow instructions in this section to remove or install a SD550 V3 node from or to the D3 Chassis.
Remove a node from the chassis
Follow instructions in this section to remove a SD550 V3 node from the D3 Chassis.
About this task
To avoid potential danger, make sure to read and follow the safety information.
R006
"Install the chassis to the rack" on page
"Install a node to the chassis" on page
filler).
"Install a hot-swap power supply" on page 63
"Complete the parts replacement" on page
.
Chapter 5
Hardware replacement procedures
56).
78).
208).
and
75