Table of Contents
Advertisement
Tape-to-tape recording from deck 1 to deck 2
The recording level and the noise reduction effect of the original
(playback) tape will be recorded on the new tape just as they were
in the original recording.
o
(Step 3 also available from the remote control)
1
Insert the playback cassette into deck 1 and
the cassette you are recording on (the editing
tape) into deck 2.
Check that the tape's erasure prevention tabs (see page 75)
are intact, and then insert the cassette into deck 2.
You cannot record on the leader tape (the first few revolutions)
so take up the leader tape in advance. (See page 44.)
2
Select the desired reverse mode.
Each time you press, one of the reverse mode indicators will
light to show which mode you select.
«—1 : Single-sided recording
: Two-sided recording (forward side—»reverse side)
In case the length of a tape loaded in deck 2 is longer
than a tape in deck 1, deck 1 repeats the playback
until deck 2 completes the two-sided recording.
(8 times max.)
OO : Two-sided recording (forward side—► reverse side)
3
Set the tape direction to (t> FWD) of deck 1
and deck 2.
Confirm that both decks are set to (>) tape direction. If (<)
indicator light, first press > play button, and press the stop
button.
4
When making a CCRT recording, press CCRT
so that the CCRT indicator lights.
(See page 43.)
5
Press one of the ONE TOUCH TAPE EDIT
(NORMAL or HIGH) to start recording with the
desired editing speed.
NOR:
When you wish to monitor the sound while re-
(NORMAL) cording
HIGH:
When you wish to record at high speed
(about 2.0 times normal speed)
After the recording has finished, the both decks will stop.
• Some TV sets generate noise that could be recorded during
tape-to-tape recording. To prevent the possibility of this, do not
use this system close to a TV set.
• Do not press CD edit recording buttons (J. FIT, ALBUM, LAST
FADE) while tape-to-tape recording is in progress. It changes the
tape-to-tape recording to the CD edit recording mode.
•For optimum results, use an editing tape of the same or higher
quality than the playback tape.
■ To stop the tape-to-tape recording
(Also available from the remote control)
Press the deck 2 stop/cassette holder open
button.
■/a
Both decks will stop.
■ To en|oy another source while recording
Press one of the input select buttons on the tuner
amplifier, and start the sound source.
You can change the volume level and tone quality without affecting
the recording.
45
Advertisement
Table of Contents
