Table of Contents
Advertisement
Making a Recording (DMk20„l y ,
| To record from the desired source
(Steps 5 and 6 also available from the remote control)
Switch on the power.
Check that the tape's erasure prevention tabs (see page 75) are
intact, and then insert the cassette into deck 2.
Check that sound processor's display shows "FLAT".
(See page 54.)
You cannot record on the leader tape (the first few revolutions) so
take up the leader tape in advance. (See page 44.)
1
Press the deck 2 stop/cassette holder open
button to load a cassette In deck 2.
2 When making a Dolby NR recording, press the
DOLBY NR so that the Dolby NR indicator (B
or C) lights.
3 Press REVERSE MODE to select the reverse
mode you want to use.
: One side will record, and then the tape will stop
automatically at the tape end.
: Both sides will record (forward side-*reverse side),
OO
then the tape will stop automatically at the tape
end.
5 Press REC PAUSE to put the cassette deck
into the recording standby mode; then select
the desired sound source.
Lights Flashes
When you record from the radio:
After pressing REC PAUSE;
1. Press BAND to select FM or MW or LW.
2. Press one of PRESET to select desired broadcast station.
Be sure you've completed the steps of "Automatic memory
presetting on page 27 or "Manual memory presetting" on
page 28.
Using the remote control, you can select the desired broad¬
cast station directly by pressing one of the preset tuning
buttons.
When you record from the compact disc:
Be sure to select the tape direction in advance. When you
want to change the tape direction, press opposite play button,
and then press the stop button.
4 When making a CCRT recording, press CCRT
so that the CCRT indicator lights.
(See page 43.)
Start of the setting
After pressing REC PAUSE;
Press the CD play button.
The recording will automatically start when you press the CD
play button (Synchro start function).
Your attention is drawn to the fact recording prerecorded
tapes or discs on other published or broadcast material may
infringe copyright laws.
I
(After about 30 seconds)
Finish of the setting
Advertisement
Table of Contents
