Table of Contents
Advertisement
6 Press one of the playback buttons to start
recording, then start playing the source to be
recorded.
O: When recording on either the forward side or both sides
<1: When recording only on the reverse side
After recording of the compact disc has completed, the cas¬
sette deck will create a non-recorded passage of about
4 seconds, and then go into the recording standby state.
Note:
Do not connect or disconnect the microphone while recording. It
breaks the recording.
■ To briefly interrupt recording from the radio
(Also available from the remote control)
When you want to cut an unnecessary part while recording;
Press REC PAUSE.
lil*«iMIMS
The cassette deck will go into the recording standby state.
To resume recording, press the playback button corresponding to
the direction in which recording is taking place.
■ To briefly interrupt recording from a compact
disc
(Also available from the remote control)
When you want to cut an unnecessary track while recording;
Press the pause button on the compact disc
player.
ii
C.,
')
■ To stop recording from a compact disc
(Also available from the remote control)
Press the CD stop button on the CD player or the
deck 2 stop/cassette holder open button on the
cassette deck.
(On the CD player)
(On the cassette deck)
a
6
When you press the CD stop button, the cassette deck will create a
non-recorded passage of about 4 seconds, and then go into the
recording standby state.
CCRT recording function
CCRT (Computer Control Record Tuning) is the function which
identifies the quality of the tape (concerning bias, level, equalizer)
automatically and sets the most desirable recording condition. After
the setting has completed, the sound processor display shows
"SET", "OK".
The CCRT setting will remain in the system's memory even after
the power is switched to the standby mode.
Notes:
•When you activate the CCRT setting, the test signal will be re¬
corded on the tape. Please note that the previous recording will be
erased.
•Do not press any input select button while the CCRT setting.
•Do not insert or remove the cassette tape after the CCRT setting
has completed. It cancels the CCRT setting.
•The CCRT setting may not be possible with the old cassette tape
or at around the end of the cassette tape. (The CCRT frame starts
to flash.) In this case, press REC PAUSE to cancel the CCRT
setting (the CCRT indicator goes off), and proceed to the next
step.
The cassette deck will create a non-recorded passage of about
4 seconds, and then go into the recording standby state.
Press one of the skip buttons until you reach the desired track, and
then press the CD play button on the CD player to resume re¬
cording.
■ To stop recording from the radio
(Also available from the remote control)
Press the deck 2 stop/cassette holder open but¬
ton on the cassette deck.
■ To cancel the CCRT setting on the way
Press the deck 2 stop/cassette holder open
button.
■/a
■ To cancel the CCRT after the CCRT setting has
completed
Press CCRT.
a/±
43
Advertisement
Table of Contents
