Combined Operation Mode 1 (Operation Using Both External Start Signal And Operation Panel) - Mitsubishi Electric FR-E560 Series Instruction Manual

3.3.4 Combined operation mode 1 (Operation using both external
start signal and operation panel)
When the start signal is provided externally (switch, relay, etc.) and the running
frequency is set from the operation panel (Pr. 79 = 3).
The external frequency setting signal and PU's forward rotation, reverse rotation and
stop keys are not accepted. (Note)
Operation command: externally connected start signal
Frequency setting:
command (multi-speed command has priority) (Refer to page 76)
Step
Power on
Switch power on.
1
Operation mode selection
Refer to page 54 and set "3" in Pr. 79 "operation mode
selection".
2
The [PU] and [EXT] indications are lit.
Start
Turn on the start switch (STF or STR).
Note: The motor does not start if both the forward and
reverse rotation switches are turned on. If both
3
switches are turned on during operation, the motor
decelerates to a stop.
The [RUN] indication is lit to indicate forward rotation,
or flickers to indicate reverse rotation.
Running frequency setting
Set the running frequency to 60.00Hz with the
4
Stop
Turn off the start switch (STF or STR).
The motor stops.
5
The [RUN] indication goes off.
STOP
Note: The key is made valid if any of "14" to "17" is set in Pr. 75 "PU stop selection".
RESET
key of the operation panel (FR-PA02
/
Description
61
OPERATION/CONTROL
) or multi-speed
-02
Image
ON
Forward rotation
Reverse
rotation
ON
/ key.
<Step setting>
Flicker
Hz RUN
3
MON
PU EXT
Hz
MON
PU EXT