Configuring Cross Connections; Default Mappings; Adding A Port-To-Port Cross Connection - Paradyne 8955 User Manual

3. Configuration Using the Web Interface

Configuring Cross Connections

Use the Configuration - Cross Connect screen to establish or delete Virtual
Channel Connections (VCCs) by port or by slot. Connections may be established
between any combination of:

Default Mappings

A DSL port's data VPI/VCI is always 0,35.
Default VC mappings to the SCP card for data service may be determined so:
Port numbers 25 through 48 are reduced (by 24) to 1 through 24, respectively, in
calculating VCI. So the VCI for Slot 3, Port 1 is the same as the VCI for Slot 3,
Port 25:

Adding a Port-to-Port Cross Connection

Procedure
To create a cross connection between specified ports:
3-12
Subtended ports
DSL ports
Network interface (uplink)
VPI is 2 for ports 1–24 and 3 for ports 25–48
VCI is (Slot * 24) + (Port number up to 24) + 7
Slot 3, Port 1: 3*24 + 1 + 7 = 80
Slot 3, Port 25: 3*24 + 25 – 24 + 7 = 80
1. On the Configuration - Cross Connect screen, click on Create New Cross
Connect. The Configuration - Cross Connect Create screen appears.
2. Enter or select the following fields:
Field
Port A
Slot
Port
VPI
Start VCI
August 2005
Description
Select from the drop-down list the slot where the card
associated with this port resides.
Select the port for the cross-connection.
Enter the VPI for this side of the cross-connection.
Enter the first VCI for this side of the cross-connection.
8900-A2-GB20-50