Paradyne 8975 Notice

ReachDSL+ Line Card Model 8975
Firmware Compatibility Notice
Document Number 8975-A2-GK40-00
May 2005
Do Not Install This Card Until You Have Checked Firmware
Do not install this card into the Broadband Loop Carrier (BLC) until you have
verified that you have the proper firmware in your SCP card. To determine the
firmware level using the web interface, select System->Firmware. Check the
Running Firmware field.
The minimum revision of firmware required is:
If your SCP card is at a firmware revision below the revision listed above, an
upgrade is required before you can install the 8975 line card. Contact your
technical support representative to obtain the latest SCP card firmware. You can
contact Paradyne Technical Support using the following phone numbers:
After downloading and switching to a valid firmware release, immediately
download at least the minimum firmware level into the alternate firmware bank to
prevent an inadvertent switch to the wrong level. Then proceed with the installation
of the line card.
Copyright 2005 Paradyne Corporation. Printed in U.S.A.
8975-A2-GK40-00
03.04.00 for Models 8411, 8412, 8413, 8414, 8415, 8416, and 8417 (SCP
cards with ATM uplinks)
04.02.00 for Model 8429 (SCP card with IP uplink)
US & Canada: 1-800-795-8004
Worldwide: 1-727-530-2340
*8975-A2-GK40-00*
*8975-A2-GK40-00*
May 2005
1