Configuring Shdsl Ports (8985) - Paradyne 8955 User Manual

Configuring SHDSL Ports (8985)

Use the Configuration - SHDSL Port screen to set parameters for a DSL port on
the 8985 line card.
Procedure
To configure a DSL port:
8900-A2-GB20-50
Field
L2 Time
Port Status
3. Click on Apply.
1. Select a Port from the drop-down list and click on Select. Current values for
the port are displayed.
2. Enter or select the following fields:
Field
Line Circuit Name
SHDSL Line Profile Name
SHDSL Alarm Profile Name
Equivalent Working Length
Port Status
3. Click on Apply.
August 2005
3. Configuration Using the Web Interface
Description
Specify the minimum number of seconds allowed between:
An entry into the low power (L2) state and the first
power trim in the low power state
Two consecutive power trims in the low power state
Select Enabled, Disabled, or Reset from the drop-down list
to determine the status of the port.
Description
Enter a name from 1 to 255 characters long to indicate to
whom the port is assigned. The following values are
reserved and cannot be used: AVAILABLE (port is not
assigned), and FAULTY (port is faulty and can not be
assigned).
Enter the name of a DSL line profile to set rates for the
port.
Enter the name of a DSL alarm profile to set alarm
thresholds for the port.
Specify the estimated length of the line. The length is
used to limit transmit rates according to local spectrum
management guidelines.
Select Enabled, Disabled, or Reset from the drop-down
list to determine the status of the port.
3-5