Creating Line Profiles For Ports (8985) - Paradyne 8955 User Manual

Creating Line Profiles for Ports (8985)

Procedure
To create a line profile for SHDSL ports:
8900-A2-GB20-50
3. Click on Apply.
1. Click on Create New Profile. The SHDSL Profile Create screen appears.
2. Enter or select the following fields:
Field
Profile Name
Max Rate
Min Rate
Mode
Remote Management
Reference Clock
Target Margin
Interface
3. Click on Apply.
August 2005
3. Configuration Using the Web Interface
Description
Specify a name for this line profile.
Enter a maximum rate from 192 to 2304 kbps.
Enter a minimum rate from 192 to 2304 kbps.
Select the regional setting supported, as specified by
ITU-T G.991.2:
Annex A
Annex B
Both
Select Enable or Disable from the drop-down list to
determine whether remote management is supported for
the network element this profile is assigned to.
Select the timing source from the drop-down list:
System – Clocking is provided by the backplane. (The
backplane clock is configured on the Configuration -
System - Clocking screen.)
Local – Clocking is provided by an onboard oscillator.
Enter a target noise margin from 2–15 dBm, or None.
Select an interface from the drop-down list:
Wire Pair 1 – The profile applies to Wire Pair 1.
Wire Pair 2 – The profile applies to Wire Pair 2.
Select Wire Pair 1 if this profile is to be used for ports that
use only one wire pair.
3-7