Paradyne Hotwire 7976 Installation Instructions Manual page 12
M/sdsl standalone termination unit with g.703 interface
Hide thumbs
Also See for Hotwire 7976:
- User manual (120 pages) ,
- Installation instructions manual (41 pages) ,
- User manual (165 pages)
Table of Contents
Advertisement
12
Table 6. Communication Protocol Options
Node IP Address
Possible Settings: 000.000.000.000 – 223.255.255.255
Default Setting: 000.000.000.000
Specifies the Node IP address.
H
Node IP Address is only available when the standalone unit is configured as an
LTU.
Node Subnet Mask
Possible Settings: 000.000.000.000 – 255.255.255.255
Default Setting: 000.000.000.000
Specifies the Node Subnet Mask.
H
Node Subnet Mask is only available when the standalone unit is configured as an
LTU.
Default Network Destination
Possible Settings: None, COM, DSL
Default Setting: None
Specifies where the default management network is connected. For example, if your
default network is connected to the COM port, select COM as the default management
network destination.
Communication Port IP Address
Possible Settings: 000.000.000.000 – 223.255.255.255
Default Setting: 000.000.000.000
Specifies the unit's Communication Port IP Address when the unit is configured as a
network communication link.
H
Communication Port IP Address is only used when the Port Use option on the
Communication Port Options menu is set to Net Link. If the COM Port IP address
is not set (000.000.000.000) the node IP address specified by the Node IP Port will
be used.
Communication Port Subnet Mask
Possible Settings: 000.000.000.000 – 255.255.255.255
Default Setting: 000.000.000.000
Specifies the unit's Communication Port Subnet Mask when the unit is configured as a
network communication link.
H
Communication Port Subnet Mask is only used when the Port Use option on the
Communication Port Options menu is set to Net Link. If the COM Port IP address
is not set (000.000.000.000), the node IP Address will be used.
Communication Port Link Protocol
Possible Settings: PPP, SLIP
Default Setting: PPP
Specifies the unit's Communication Port link layer protocol when the unit is configured
as a network communication link.
H
Communication Port Link Protocol is only used when the Port Use option on the
Communication Port Options menu is set to Net Link.
March 1999
7976-A2-GZ40-00
Advertisement
Table of Contents
