Paradyne COMSPHERE 3821Plus User Manual page 90

COMSPHERE 3821Plus Modem
S14 – Asymmetric Rate Mode
Register determines whether VF rates for transmitting and receiving are identical when using V.34 modulation. Enabling
the function permits the two rates to be different.
Register has the following values:
0 = Enable
1 = Disable
Factory setting is Enable.
S18 – Test Timeout
Sets the duration (in seconds) for the modem tests. This automatically cancels any test in progress after the time of this
register expires. Any test can be manually canceled by issuing the escape sequence (+++) followed by the &T0
command.
Enter a value from 0–255 seconds. (A value of 0 disables this register.)
Factory setting is Disable.
S26 – RTS-to-CTS Delay
Sets the length of time (in 10-millisecond increments) the modem waits after receiving RTS before issuing CTS to the
DTE.
Enter a value from 0–255.
Factory setting is 0 milliseconds.
S39 – Receive Buffer Disconnect Delay
Determines the maximum amount of time the modem can continue to send data in its Receive Buffer to the DTE after the
modem is commanded by the DTE to disconnect, or after the modem detects a line disconnect.
Register has the following values:
0 = Disable (Immediate disconnect)
1 = 1 second
2 = 2 seconds
255 = 255 seconds
Factory setting is Disable.
S40 – Auto Make Busy
Register determines whether the modem automatically goes into a Make Busy state in the following conditions: during a
Local Analog Loop Test; during a Self Test not invoked by powering on the modem, and after a failed Self Test; during a
DTE or NMS download, and after a failed download; and upon a switch to the Service Line.
WARNING: Auto Make Busy should be enabled only for modems connected to a PBX, or to a local phone system that
allows it.
Register has the following values:
0 = Disable
1 = Enable
Factory setting is Disable.
4-18
Table 4-2
(3 of 10)
3821 Plus S-Registers
February 1998 3821-A2-GB20-30