Paradyne COMSPHERE 3821Plus User Manual page 78

COMSPHERE 3821Plus Modem
X n – Extended Result Codes, Dial Tone Detect, and Busy Tone Detect
The X n command sets three configuration options simultaneously:
Result Codes
X0 Disable
X1 Enable
X2 Enable
X3 Enable
X4 Enable
X5 Add/EC
X6 Add/V42,MNP
X7 Use DTE Rate
EXTENDED RESULT CODES
Informational messages such as VF (line) connect rate and Error Control are displayed with the result codes.
Disable. Displays basic result codes: OK, CONNECT, RING, NO CARRIER, and ERROR.
Enable. Displays basic result codes in addition to the CONNECT rate message (for example, CONNECT 14400).
Add/EC. If error control is negotiated, attaches the /EC suffix to the CONNECT rate message.
Add/V42,MNP. Attaches the V42b, V42, MNP5, MNP4, MNP3, MNP2, or NoEC suffixes to the CONNECT rate message.
Use DTE Rate. Displays DTE data rate instead of line CONNECT rate message.
DIAL TONE DETECT
Sets the modem for dial tone detection (enable) or blind dialing (disable).
Disable. Sets the modem for blind dialing.
Enable. Sets the modem for dial tone detect.
BUSY TONE DETECT
Sets the modem to monitor for Busy Tone (Enable) or ignore Busy Tone (Disable).
Disable. Modem ignores busy tone.
Enable. Modem monitors for busy tone.
NOTE: The default and permitted settings of this option are country-dependent. See
Y n – Long Space Disconnect
Determines the modem's response to a continuous spacing condition sent from the remote modem when it goes on-hook.
Issuing a long space is one method of disconnecting a call.
Y, Y0 Disable. Ignores long space.
Y1 Enable. Disconnects if long space is detected. Enables transmission of a long space.
Z n – Reset and Load Active
Z, Z0 Loads configuration options from Active (Saved) to Active (Operating).
Z1 Loads configuration options from Customer 1 to Active (Operating).
Z2 Loads configuration from Customer 2 to Active (Operating).
Z3 Loads configuration options from Active (Saved) to Active (Operating) and performs a reset.
Z9 Performs a full modem reset as if the modem were powered Off and ON.
4-6
3821 Plus AT Commands
Extended Dial Tone
Detect
Disable
Disable
Enable
Disable
Enable
Enable
Enable
Enable
Table 4-1
(4 of 13)
Busy Tone
Detect
Disable
Disable
Disable
Enable
Enable
Enable
Enable
Enable
February 1998
Appendix H.
3821-A2-GB20-30