Paradyne COMSPHERE 3821Plus User Manual page 27

Zhone comsphere 3821plus modems: user guide
Hide thumbs Also See for COMSPHERE 3821Plus:
Table of Contents

Advertisement

COMSPHERE 3821Plus Modem
Normal Call
Setup Messages
Off Hook
The modem is off-hook and waiting to dial a telephone number.
Dialing
The remote modem is being dialed.
Training
The modem is training or retraining.
EC Negotiating
The local and remote modems are negotiating the highest possible level of error control
compatible between both modems. Once a level is selected, this LCD message disappears.
Call Failure
Messages
Busy Signal
The answering modem is busy.
Delayed Number
As a result of failed call attempts, this number may not be called at this time. Try again later.
(Only appears in countries where the number of repeated call attempts is limited.)
Dial Line in Use
The modem is already operating on dial networks when another call attempt has been issued.
Forbidden Number
As a result of failed call attempts, this number may not be called again. (Only appears in
countries where the number of repeated call attempts is limited.)
Invalid Number
The modem has attempted to dial from a directory location that has no phone number.
No Answer Tone
No answer tone has been received within the time limit specified by the No Answer Timeout
configuration option. The network tones (if any) could not be interpreted by the modem.
No Dial – DTR
The modem cannot dial because DTR is Off.
No Dial – Test
The modem cannot dial because it is running a Test.
No Dial Tone
The modem has aborted the call because it cannot detect a dial tone.
No Quiet Answer
The modem has detected No Quiet Answer (@) before the time-out setting of the No Answer
Disconnect configuration option.
Ringback Timeout
The answering modem has not answered within the time limit specified by the No Answer
Timeout configuration option; a ringback signal was detected.
Wrong Call
The call was answered, but not by a modem; there was no answer tone.
Call Disconnect
Messages
ATH Disconnect
The modem has disconnected due to an ATH command.
Bad Lines Disc
The modem has disconnected because the lines do not support the modulation and/or data rate
selected.
No Carrier Disc
The modem disconnects due to the loss of carrier signal from the remote modem.
DTR Disconnect
The modem has disconnected due to the loss of DTR from the DTE.
EC Disconnect
The modem has disconnected due to failure to negotiate Error Control mode.
3-4
Table 3-1
(2 of 3)
Top-Level Menu Status
Indicates
Indicates
Indicates
February 1998
3821-A2-GB20-30

Advertisement

Table of Contents
loading

Table of Contents