Paradyne COMSPHERE 3821Plus User Manual page 112

Zhone comsphere 3821plus modems: user guide
Hide thumbs Also See for COMSPHERE 3821Plus:
Table of Contents

Advertisement

COMSPHERE 3821Plus Modem
DTE_PW_TermChar: 013
Nxt
013
DTE Password Termination Character. Allows you to change the ASCII character used to indicate the end of a
password or User ID entered by an originating user. This character can be set to any ASCII value from 1 to 63 or
123 to 127.
The factory default is 13 (ASCII carriage return).
DTE_PW_BkSpChar: 008
Nxt
008
DTE Password Backspace Character. Sets the character that is used to perform a backspace in security mode. This
character can be set to any ASCII value from 1 to 63 or 123 to 127.
The factory default is 08 (ASCII backspace).
Get_User_ID: Disable
Nxt Disable Enable
Get User ID. Determines whether the remote user is prompted for an NMS-defined logon ID once the modems have
completed initial handshaking. For consistent operation from the remote user's viewpoint, all modems in a modem
group must use the same setting.
Disable – The user is prompted only for a password (if required by the setting of Answer Security Mode or the
configuration of the VF-side password).
Enable – The user is prompted for a login ID and then a password (if required by the setting of Answer Security
Mode or the configuration of the VF-side password). NMS sends a disconnect command to the local modem if the
login ID is invalid.
The factory default is Disable.
NMS_Reporting: 00
Nxt
00
NMS Reporting. Determines whether and how dial access security events are reported to the NMS controller. The
possible values, 00–15, represent a bit map. The bits are normally set using the NMS controller.
The value of NMS_Reporting is not affected by loading a factory default template. The initial value when the modem
is shipped is 00.
Answer_Secur: No_Answ_Sec
Nxt No_Answ_Sec DTE_Only VF_&_DTE VF_w/_DTE
Answer Access Security Mode. This configuration option is read-only and cannot be changed from the Configure
branch; it can be changed only from the Security branch.
The setting of Answer Security determines the type of access security protection provided by the modem. It can be
disabled using the No_Answ_Sec setting, or it can be enabled with the DTE_Only, VF_&_DTE, or VF_w/_DTE
settings.
The factory default is No_Answ_Sec.
7-10
Table 7-5
(2 of 3)
Security Configuration Options
February 1998
3821-A2-GB20-30

Advertisement

Table of Contents
loading

Table of Contents