Paradyne COMSPHERE 3821Plus User Manual page 54

BusyTone Detect: Enable
Nxt Enable Disable
Busy Tone Detect. Sets the modem to monitor for Busy Tone (Enable) or ignore Busy Tone (Disable).
This configuration option is normally enabled; however, if the modem receives false busy tones, this configuration option
can be disabled and the modem ignores all busy tones.
The factory default is Enable.
AT command equivalent is X n .
''," Pause Time: 2sec
Nxt 2sec 4sec 6sec 8sec 10sec 20sec
Pause Time. Determines the number of seconds the modem pauses when it encounters a comma (,) in the dial
command string.
NOTE: Although SDCP selections are limited (2, 4, 6, 8, 10, or 20), values set by the AT commands can be displayed as
0 to 255 seconds.
The factory default is 2sec.
NOTE: The default and permitted settings of this option are country-dependent. See
AT command equivalent is S-register S8= n .
NoAnswer Timout: 45sec
Nxt 45sec 30sec 60sec 120sec
No Answer Abort Time-out. Determines the number of seconds an originating modem waits before abandoning a call
attempt when no answer tone is received.
NOTE: Although SDCP selections are limited (30, 45, 60, or 120), values set by AT commands can display from 1 to
255 seconds.
NOTE: The default and permitted settings of this option are country-dependent. See
AT command equivalent is S-register S7= n .
Fast Disconnect: Disable
Nxt Disable Enable
Fast Disconnect. Allows the modem to disconnect immediately after receiving a disconnect command from a local DTE
or its own diagnostic control panel.
Disable – The modem follows its normal disconnect sequence by issuing a cleardown sequence or long space
disconnect. This is also known as a graceful disconnect since the other modem receives advance notice of a
disconnection.
Enable – Use this setting if the DTE requires that the modem be made available as soon as possible after receiving a
disconnect command.
NOTE: This abrupt method of disconnecting may cause problems with the remote modem, which may interpret the
disconnection as an error instead of a valid disconnect.
The factory default is Disable.
AT command equivalent is S-register S85= n .
3821-A2-GB20-30
Table 3-6
(2 of 4)
Line Dialer Configuration Options
February 1998
SDCP Menus
Appendix H.
Appendix H.
3-31