Table of Contents
Advertisement
3. CLI Commands
Inband Management VLAN ID
If your network is running VLANs to facilitate packet direction or promote packet
security, you must set Inband MGMT (Management) VLAN ID. Do not set Inband
MGMT VLAN ID if your network is not running VLANs.
Default: 0
Inband Management VLAN ID applies only to remote network management. It
does not apply to direct connections between your PC and the COM port.
Password
Passwords may be up to 15 case-sensitive alphanumeric characters. You will be
prompted for values. Only one password may be assigned per each class of user:
all general users utilize the same password and all superusers utilize the same
password.
General and Superuser passwords cannot be configured remotely via Telnet.
General User (Read Only)
General Users' access to DSLAM management via CLI is limited to the HELP [?],
LOGOUT and SHOW commands.
Default: Password
Superuser (Read/Write)
Superusers have unlimited access to DSLAM management via CLI.
Default: Password
3-6
[system name] ->SET SLOT [13 or 14 for the IPD12000, 5 for the
IPD4000, 1 for the Micro DSLAM] INBAND_MGMT_VLAN_ID [0-4085]
Example: [system name] ->set slot 13 inband_mgmt_vlan_id 100
[system name] ->SET SLOT [13 or 14 for the IPD12000, 5 for the
IPD4000, 1 for the Micro DSLAM] GENERAL_PASSWORD
Example: [system name] ->set slot 5 general_password
Password: ********
Verify: ********
[system name] ->SET SLOT [13 or 14 for the IPD12000, 5 for the
IPD4000, 1 for the Micro DSLAM] SUPERUSER_PASSWORD
Example: [system name] ->set slot 5 superuser_password
Password: ********
Verify: ********
October 2004
CLI-A2-GB20-00
Advertisement
Table of Contents
