Table of Contents
Advertisement
Device Memory
Configuration backup is inherent in Micro DSLAMs and IP DSLAMs. Upon initial
power up, default parameters will remain in place unless changed through CLI,
SNMP (Simple Network Management Protocol) or NMS (Paradyne's Network
Management System). Once changed, new configurations will automatically be
recorded in both RAM and NVRAM:
„
„
Local Files
Both system and port configurations can be saved on your PC or local network as
a backup and/or for use as a template for future configurations. Once a DSLAM
has been configured as desired, the settings can be uploaded (from the DSLAM to
a local file) through a Trivial File Transfer Protocol (TFTP) tool with a GET
command and the following information:
„
„
Configuration files can also be flash downloaded from a local file to a DSLAM.
Replace the GET command with a PUT command. Refer to your TFTP user
manual for further instruction.
CLI-A2-GB20-00
RAM (Random Access Memory)
Data stored in RAM will be erased if the device loses power.
NVRAM (Non-Volatile Random Access Memory)
Data stored in NVRAM will remain intact (even if the device loses power)
unless deliberately cleared or reconfigured.
Backup File
A DSLAM backup file records all system and port configurations.
Item
Data Needed for Backup
Host Name:
DSLAM IP Address (xxx.xxx.xxx.xxx)
Remote
NVR_BACKUP.BIN.[superuser
Filename:
password]
Local
user preference
Filename:
Template File
A DSLAM template file records all system and port configurations except IP
address.
Item
Data Needed for Template
Host Name:
DSLAM IP Address (xxx.xxx.xxx.xxx)
Remote
NVR_CFG.BIN.[superuser password]
Filename:
Local
user preference
Filename:
October 2004
1. CLI Overview
Example
185.172.164.144
nvr_backup.bin.Password
dslam27_mum13_backup.bin
Example
185.172.164.144
nvr_cfg.bin.Password
n2n_dslam12000_template.bin
1-3
Advertisement
Table of Contents
