Table of Contents
Advertisement
1. CLI Overview
IP DSLAM Data Management
Replacing an Interface Module
A replacement module (of like model) will take on the same configurations as the
previous module only if the Multiplexer Uplink Module (MUM) remains in the
chassis and the chassis retains power during the interim. Otherwise replacement
module configurations will revert to original default settings.
If the replacement interface module is:
The same model as the previous module and new or
unconfigured
The same model as the previous module and already
configured
A different model than the previous module and new or
unconfigured
A different model than the previous module and already
configured
Replacing a Multiplexer Uplink Module (MUM)
Paradyne recommends clearing the NVRAM of a previously configured MUM
before using it as a replacement in a different chassis. Once NVRAM has been
cleared, the MUM will revert to original default settings.
If the replacement MUM is:
The same model as the previous MUM and new or
unconfigured
A different model than the previous MUM and new or
unconfigured
A replacement MUM will take on the same configurations as the previous MUM
only if there is at least one interface module installed in the IP DSLAM and the IP
DSLAM retains power during the interim. Otherwise, the replacement MUM will
revert to original default settings.
1-4
Then the module configuration will revert to:
The same configurations as the previous module
The same configurations as the previous module
Original default settings (see
page 1-2)
Original default settings (see
page 1-2)
Then chassis and interface module configurations
will revert to:
The same configurations as the previous MUM
The same configurations as the previous MUM
October 2004
Default Settings
on
Default Settings
on
CLI-A2-GB20-00
Advertisement
Table of Contents
