Table of Contents
Advertisement
Front Parking Aids, Rear Parking Aids and Side
Sensing System*
These systems warn you of obstacles within a certain
range of your vehicle. As you move closer to the
detected obstacle, the rate of the warning tone
increases in frequency. The side sensing system
uses the front and rear side sensors to detect and
map obstacles that are near the sides of your
vehicle. The front sensors are active when the
transmission is in any position other than park (P).
The rear sensors are active when the vehicle is in
reverse (R) and your vehicle is traveling at a
low speed.
Keep the sensors, located on the bumper or fascia,
free from snow, ice and large accumulations of dirt. If
the sensors are covered, the system's accuracy can
be affected. Do not clean the sensors with sharp
objects. See the Parking Aids chapter in your
Owner's Manual for complete information on your
vehicle's sensing systems.
Driver Alert
The system automatically monitors your driving
behavior using various inputs, including the front
camera sensor. If the system detects that driver
alertness is below a certain threshold, the system
alerts you using a tone and a message in the
information display. The warning system works in
*if equipped
two stages. At first, the system issues a temporary
warning that you need to take a rest. This message
only appears for a short time. If the system detects
further reduced driver alertness, the system issues
another warning that remains in the information
display for a longer time. Press OK on the steering
wheel to clear the warning. You may switch the
system on or off through the information display.
Active Park Assist*
Detects an available parking space and automatically
steers the vehicle into the space. The system then
steers, accelerates, brakes and shifts gear as
required to maneuver into or out of a parking space.
To use Active Park Assist, press the
below the display screen, then touch the Active Park
Assist icon on the display screen to bring up full
screen notifications. Then, press the soft keys on the
display screen to switch between Parallel Park In,
Perpendicular Park In or Parallel Park Out
parking modes.
Use the direction indicator lever to select from which
direction you want to begin searching, either to the
left-hand or right-hand side of your vehicle.
Drive your vehicle approximately 3 feet (1 meter)
away from and parallel to the other parked vehicles
when searching for a parking space. A tone sounds
and a message appears in the information display
when Active Park Assist finds a suitable parking
space. To park, press and hold the brake pedal then
release the steering wheel and shift into neutral (N).
Press and hold the
pedal to allow the vehicle to park.
You can slow down your vehicle at any time by
pressing the brake pedal. The vehicle shifts into park
(P) when parking is complete.
Use the park out assist feature when your vehicle is
at rest in a parallel parking space. Press the
button and use the direction indicator lever to
choose the direction to exit the space. Press and
hold the brake pedal. Release the steering wheel
button just
and shift into neutral (N). You can then release the
parking brake and press and hold the Active Park
Assist button. Release the brake pedal to allow the
vehicle to move.
Note: After the system drives your vehicle to a
position where you can exit the parking space in a
forward movement, a message appears instructing
you to take full control of your vehicle.
For complete information, refer to the Parking Aids
chapter of your Owner's Manual.
2 0 2 4 A V I A T O R
button. Release the brake
19
Advertisement
Table of Contents
