Sliding Table Adjustment; Fig 21 - Jet JTS-600X-M Operating Instructions Manual

7.8 Crosscut table setup
Crosscut table setup shall never be
performed when the machine is
running.
Lift the crosscut table onto telescopic
arm and slide onto sliding table T-
groove and lock in place (Fig 21).

Fig 21

Crosscut table and telescopic arm are
rough aligned ex works (The table
surface must be in level with the
sliding table).
Telescopic arm adjustment:
Mount the crosscut table at the rear of
the sliding table.
Move the sliding table to the rear and
align the crosscut table height with
hex nuts (S).
Use crosscut fence profile to check.
Move the sliding table forward.
If the crosscut table rises, turn the
eccentric axis (T) to the left
(clockwise) until the crosscut table
does not move in height during sliding
table travel.
Fig 22
Finish alignment by setting crosscut
table and machine table in level with
nuts (S).
Start the machine with care.
7.9 Crosscut fence setup
Crosscut fence setup shall never be
performed when the machine is
running.
The cross-cut table has 2 precision
holes, allowing the crosscut fence to
be put in 2 positions:
At the back and front of the crosscut
table.
Simply put the fence onto the cross-
cut table and lock it in position using
the supplied knobs.
The 90° adjustable stops (R, Fig 21)
are factory set.
The fence scale is factory set.
Adjustment can be made by moving
the pivot point along the T-grove.
Confirm by test cuts.
When, after some time, the plastic
protection cap at the front on the
cross-cut fence is cut away, a new
one has to be installed
(part no.: JTS600-178).
8. Maintenance and inspection
General notes:
Maintenance, cleaning and repair
work may only be carried out after
the machine is protected against
accidental starting by pulling the
mains plug.
Repair and maintenance work on the
electrical system may only be carried
out by a qualified electrician.
Inspect the proper function of the dust
extraction daily.
Keep the inside of the cabinet clear of
sawdust and wood chips. Make sure
the motor fan and fan cover are also
kept clear of sawdust.
All protective and safety devices must
be re-attached immediately after
completed cleaning, repair and
maintenance work.
Defective safety devices must be
replaced immediately.
A worn table insert must be replaced.
Removal of dust chute blockage:
Cut off pieces can block off the chip
flow in the lower saw guard.
Disconnect the machine form the
power source, pull mains plug.
Remove the front cabinet cover.
10
Remove the lock knob and lower the
dust port (Fig 23).
Remove blocking parts.
Fig 23
Reinstall the dust port and front
cabinet cover immediately.
Cleaning:
Clean the machine regularly.
Remove rust from the table e.g. with
WD-40® and a Scotch-Brite™ Hand
Pad.
Never smoke while cleaning the
machine, and especially when using
petrol, kerosene or other inflammable
products.
This could lead to an explosion and
serious burns for the operator.
Saw blades:
Check saw blades regularly for faults.
Replace a defective sawblades
immediately.
Only use sharp and properly set saw
blades.
The servicing of saw blades should
only be performed by a trained
person.
Main drive belt tensioning:
The machine is equipped with a
durable Poly-V belt
In case of belt slip (yelling noise), the
belt must be tightened.
Disconnect the machine form the
power source, pull mains plug.
Remove the front cabinet cover.
Tilt the sawblade to 45° for better
access.
Loosen the 2 hex bolts (Fig 24).