Lincoln Electric DLF-82 Operator's Manual page 22

DLF-82
®
SETTINGS MENUS (CONTINUED)
Starting Procedure
Starting procedure has a factory default setting of Auto. If desired,
a custom starting routine can be set. If active, the DLF-82 will
strike the arc with the set WFS and Voltage and then ramp over
the set amount of time to the welding WFS and Voltage.
A short press of the bottom encoder push button will select the
menu item that is blinking ("Start"). After the press, the values to
be set will blink on the upper seven-segment displays and the
right-hand side of the lower alphanumeric display. Rotations of
the upper left knob will set the start wire feed speed.
Rotating the upper right knob will set the start volts setting.
Start time can be set to a time in seconds. The available
settings are OFF to 10s in increments of 0.1 seconds. Start
times are unaffected by limits settings.
Blinks
PROCESS SELECT
PRESS FOR MENU
Menu/Process Select
Encoder Push Button
FIGURE B.11
Crater / Ending procedure has a factory default setting of Auto. If
desired, a custom Crater routine can be set. If active, the
DLF-82 will ramp up or down from the welding WFS and Voltage
to the Crater WFS and Voltage over the set amount of time.
A short press of the bottom knob will select the menu item that
is blinking ("Crater"). After the press, the values to be set will
blink on the upper seven-segment displays and the right-hand
side of the lower alphanumeric display. Rotating the upper left
encoder knob will set the crater wire feed speed. Rotating the
upper right encoder knob will set the crater volts settings.
The settings are unaffected by limits settings.
Crater time can be set to a time in seconds. The available
settings are OFF to 10s in increments of 0.1 seconds.
MEM
Memory/Back
Blinks
Push Button
-