Table of Contents
Advertisement
DLF-82
®
While Idle:
The left display shows the preset wire feed speed. The right
display shows the preset voltage or the preset trim. The
corresponding LED on the sides of the display will light to indicate
what is being displayed.
While Welding:
The value in the left display will be either amps or actual wire feed
speed, depending upon the selection chosen in the set-up menu.
T
e h
o c
e r r
p s
n o
i d
g n
L
D E
o
t n
value on the left display will show either actual amps or wire feed
speed depending upon the selection chosen in the setup menu.
The value on the right display will show actual voltage. The
corresponding LED on the sides of the display will light to indicate
what is being displayed.
ACTUAL AMPERAGE
PROCESS SELECT
FIGURE B.1
PRESET VOLTAGE DISPLAY IN NON-SYNERGIC WELDING
The preset voltage display is determined by the welding mode.
For non-synergic welding modes, the right display will show set
voltage.
e h
s
d i
s e
o
t f
e h
d
s i
l p
y a
w
l l i
g i l
t h
ACTUAL VOLTAGE
PRESET VOLTAGE DISPLAY IN SYNERGIC WELDING
For synergic CV modes, the right display will show volts.
When the right knob is rotated, the display will show an upper
or lower bar if the voltage is above or below the ideal voltage
Preset voltage above ideal (upper bar displayed for 1 second).
T .
e h
Preset voltage is ideal.
Preset voltage below ideal (lower bar displayed for 1 second).
Note: Changing the WFS will result in the preset voltage
following the set wire feed speed as a synergic setting.
PRESET DISPLAY IN SYNERGIC PULSE WELDING
Pulse welding controls the arc length with "Trim" instead of
voltage. When trim is adjusted with the knob, the machine
automatically recalculates the voltage, current and time of
each part of the pulse waveform for the best result. Trim
adjusts the arc length and ranges from 0.50 to 1.50.
Note: The trim display can be changed back to showing volts
in the set-up menu.
B-4
FIGURE B.
FIGURE B.
FIGURE B.4
Advertisement
Table of Contents
