Table of Contents
Advertisement
DLF-82
®
There are 3 levels of menus that can be accessed on the DLF-82:
process-related settings, feeder settings, and advanced settings.
•
Settings Menu (Welding process related)
•
Setup Menu (Determines how the UI displays info)
•
Advanced Setup Menu (Factory info and diagnostics)
To enter the welding menu system, press and hold the bottom
knob pushbutton for at least .5 seconds.
Within settings, rotating the knob will cycle through the
"Settings menu" items.
A press of the left knob will select the welding menu item that
is blinking. After the press, the parameter value to be set will
blink.
Rotating the bottom encoder knob will change the selected
value.
Pressing the bottom encoder knob again will store the value
that has been set.
FIGURE B.
Settings Menu items are:
•
Arc Control
•
Run-in Speed (as a % of welding WFS)
•
•
•
Burnback Time
•
Start Settings
•
Crater Settings
•
Setup Menu
Arc Control
In CV modes arc control is used to vary the pinch or inductance
entered by pressing the bottom encoder push button. This will
It can be adjusted from the range -10.0 to +10.0.
Run-in Speed (% of weld WFS)
Run-in speed is used to modify the wire feed speed during the
wire will begin to be fed at the run in speed. By default it is set
Once contact is made between wire and work piece the wire
feed speed will ramp up to the preset speed.
This setting changes the amount of time that the solenoid is held
closed before the welding torch is energized and the wire is fed.
trigger is pulled.
range can be adjusted to be off or adjusted between 0.1s and
10.0s.
This setting changes the amount of time that the gas solenoid is
held closed after the trigger is releases. The welding gas will
turned off here as well. It can also be adjusted between 0.1s and
10.0s.
Burnback Time
the trigger is released and the wire is no longer being fed. It can
be used to reduce the wire stickout after a weld.
The default burnback time is Auto. It can be turned off in the
menu or adjusted between 0.05s - 0.250s.
B-8
Advertisement
Table of Contents
