Paradyne 6212 User Manual page 36

3. Using the Web Interface
To configure the router as a bridge:
Procedure
Figure 3-8.
To complete the connection you must now click the Apply button. The Apply button
will temporarily save this connection. To make the change permanent, click on
3-12
1. From the Home page, click on Setup and then click on New Connection. The
default PPPoE connection setup is displayed.
2. At the Type field select Bridge from the drop-down list. The Bridge connection
setup page is displayed (see
3. Give your Bridge connection a unique name; the name must not have spaces
and cannot begin with numbers.
4. Select a PVC Sharing type of Disable, Enable, or VLAN.
5. Select or enter a VPI and VCI. (Your DSL service provider or your ISP will
supply these.) For VLAN, specify a VLAN ID and priority.
6. Select the encapsulation type (LLC or VC); if you are not sure which to use,
just use the default mode.
7. Select the quality of service (QoS). Leave the default value if you are unsure
or the ISP did not provide this information. Depending on the QoS you select,
you may also enter:
— PCR (Peak Cell Rate)
— SCR (Sustainable Cell Rate)
— MBS (Maximum Burst Size)
— CDVT (Cell Delay Variation Tolerance)
Bridged Connection Setup
January 2005
Figure 3-8).
6212-A2-GB22-00