Configuring The Wan - Paradyne 6212 User Manual

3. Using the Web Interface

Configuring the WAN

Before the router will pass any data between the LAN interface and the WAN
interface, the WAN side of the router must be configured. Depending upon your
ISP, you will need some or all of the information listed below before you can
properly configure the WAN:
If you use PPPoA or PPPoE, you also need these values from your ISP:
If you use multiprotocol encapsulation over ATM Adaptation Layer 5 (as described
in RFC 1483), you may need these values from your ISP:
Since multiple users can use the router, the router can simultaneously support
multiple connection types. You must set up different profiles for each connection.
The router supports the following protocols:
3-4
Your DSL line's Virtual Path Identifier (VPI) and Virtual Channel Identifier (VCI)
Your DSL encapsulation type and multiplexing mode
Your DSL training mode (default is MMODE)
Your username and password
Your DSL fixed Internet IP address
Your subnet mask
Your default gateway IP address
Your primary DNS IP address
DHCP
PPPoA (RFC 2364)
PPPoE (RFC 2516)
Static
Bridged
January 2005 6212-A2-GB22-00