Cli Commands; Adsl - Paradyne 6211 Command Manual

6211-I1 ADSL2+ Router Command Line Interface User's Guide

CLI Commands

adsl

Name
adsl Allows you to control the ADSL driver.
Synopsis
adsl start [options]
adsl stop
adsl connection [options]
adsl configure [options]
adsl bert [options]
adsl info [options]
adsl version
adsl help
Description
The adsl command controls the ADSL driver. This utility:
•
starts and stops the driver.
•
activates, deactivates, and controls the ADSL connection.
•
configures the ADSL driver and connection parameters.
•
starts, stops, and monitors the Bit Error Rate Test (BERT).
•
displays status and information of the ADSL driver and connection.
•
displays statistics for the ADSL driver and connection.
All information is displayed to stdout. A program or shell script that calls this utility can redirect stdout to a file
and then parse the file in order to interpret the displayed output.
Commands
bert
Controls the ADSL BERT. This command can start/stop BERT and monitor its results.
configure
Configures ADSL connection parameters. This command takes the same parameters as the "start"
command, except for [--up]. This command causes the ADSL PHY to retrain.
connection
Controls ADSL connection modes, such as up and down, and several special test modes. This
command can also be used to specify tone selection for upstream and downstream.
help
Shows the syntax of the adsl command.
info
Displays information about the ADSL driver and PHY status.
start
Starts the ADSL driver. This command calls BcmAdsl_Initialize to initialize the driver and
BcmAdsl_ConnectionStart to start the ADSL PHY connection if [--up] is specified. This command takes
parameters that can specify various connection modes. These parameters are the same as in
"configure" command.
8