Editing onto Another Tape
You can create your own video programme by editing with any other
Q
8 mm,
H1B
Hi8, VMS VHS,
SVDS
S-VHS, WISH VHSC, SWKH S-VHSC,
IB
Betamax or uawm ED Betamax VCR that has audio/videt>
inputs.
Before Editing
Connect the camcorder to the VCR using the A/V connecting cable (supplied), (p.23).
Set the input selector on the VCR to LINE, if available. Note that the data code of that tape is erased.
(
1
)
Set the POWER switch to VTR.
(
2
)
Set EDIT to ON in the menu system (p.31).
I*=lgaa
If your VCR is a monaural type, connect only the white plug for audio on both the camcorder and VCR.
Starting Editing
(1) Insert a blank tape (or a tape you want to record over) into the VCR. And insert your recorded tape
into the camcorder.
(
2
)
Play back the recorded tape on the camcorder until you locate the point where
you want to start editing, then set the camcorder in the playback pause mode.
(
3
)
On the VCR, locate the
recording start point and set the VCR in the recording pause mode.
(
4
)
Press II on the camcorder and
VCR simultaneously to start editing.
To Edit More Scenes
Repeat steps 2 to 4.
To Stop Editing Momentarily
Press II on the VCR.
To Stop Editing
Press □ on both the camcorder and the VCR.
Use of the EDITSEARCH button
You can play back the tape in normal/reverse direction by keep pressing EDITSEARCH during playback
pause mode. You can also play back still pictures successively at specific intervals by pressing
EDITSEARCH intermittently.